Balun RCT-11050

46.20 

Categoría: Etiqueta:

Descripción

Balun RCT-11050 1:1 5kW

RCOMTECH High-Power Baluns and Transmission Line Transformers let your antenna perform to its fullest potential and reduce the stresses on your equipment. RCOMTECH baluns will deliver the power to your antenna with minimum loss and perform a perfect transition from balanced to unbalanced. This will result in the strongest signal that your antenna is capable of producing consistently with the lowest SWR under given conditions.

This results in less stress on your transmitter so that components will last longer and operate better. RCOMTCH baluns exhibit far wider bandwidths than conventional baluns because more of the flux is confined to the immediate vicinity of the core, so much more energy goes to your antenna. Extremely high efficiency is achieved over the entire frequency range.

1:1 current mode (choke) 5kW balun characteristics

Custom imported high efficiency low permeability ferrite with coating seal
Widest operating frequency range
Lowest core pressure
Eliminate common common mode currents and radiation from feeders
Reduce transmission RFI and receive noise
Insertion loss is less than 0.02 dB
High standard waterproof box, long-term anti-UV
SO-239 nickel plated connector with waterproof gasket and TEFLON insulation (optional silver plated -X)
lifetime warranty

Features :
Part Number :    RCT-11050
Core Type :    Outstanding low permeability ferrite mix coated toroid core with special design for    maximum bandwidth by Fair-Rite Product
Winding Type :    Single core/Coaxial
Winding Material :    Coaxial MIL Spec Cable to MIL-C-17 50 ohm coax including Silver center conductor,    PTFE dielectric, Maximum attenuation, and VSWR levels
Ratio :    1:1
Power Handling(CW/SSB) :    5kW / 5kW
Frequency Range :    1 to 54 MHz
Band of Operation :    160M – 6M
Insertion Loss :    Less than 0.02db
Termination Impedance :    50 Ohms
Termination Type :    1/4-20 Studs/Hex nuts/Wing nuts/Eyebolts
Connectors :    Gasketed SO-239 connectors are nickel-plated with Teflon insulation (option X silver    plated)
Hardware :    All Stainless Steel
Enclosure Type :    NEMA rated 4x junction box provide sturdy weatherproof and an additional level of    protection against corrosion
Dimensions :    4 in. x 4 in. x 2 in.
Additional :    Very high efficiency (98-99%)
Mounting Type :    Antenna Mounting Options are available in the Accessories section
Warranty :    Lifetime

error: Content is protected !!